AKDY AKY0130SS Manuel d'installation

1 UNDER CABINET RANGE HOOD Universal Installation Instructions and Use & Care Guide For questions about features, operation/performance parts, ac

10 STEP 1: CONNECTING VENT SYSTEM Air Flow Flapper Installation 1. Install the non-return air flap on top of hood with M5 X 8 screws (Part B). 2.

11 STEP 2: MOUNTING THE RANGE HOOD 1. After preparing the location, use two or more people, hang the range hood on the 8 mounting screws (Part A),

12 STEP 3: ELECTRICAL CONNECTION 1. Connect the three prong cable (not included) to the existing cable on the range hood. 2. Connect the White to

13 RANGE HOOD USE The range hood is designed to remove smoke, vapors, and odors. For best results, start the hood before cooking. After, the cooking

14 RANGE HOOD CONTROLS Operating the lights The On/Off light button controls both lights. Press once for “ON” and again for “OFF”. Operating the

15 RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace panel filters

16 Replacing the LED/Halogen light Turn off the range hood and allow the LED/Halogen to cool. To avoid damage or decreasing the life of the new bulb

17 TROUBLE SHOOTING Potential Effect of Failure Potential Cause(s) Recommended Action(s) Lamp does not turn ON Electronic Control does not work.

18 in the white plastic. - Push inwards the motor/lamp connectors until the locking system on connectors is well attached. 5) Connect hood to power s

19 SHOPRANGEHOODS.COM MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For three year from the date of purchase, when this major appliance is operated and

2 TABLE OF CONTENTS RANGE HOOD SAFETY ...2 INSTALLATIO

3 IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: Use this unit only

4 INSTALLATION REQUIREMENT TOOLS AND PARTS REQUIREMENTS Electrical drill or ratchet driver 1/2” drill bit for drilling pilot holes 1 ¼” drill bit fo

5 INSTALLATION DIMENSIONS A. Countertop height B. Hood height from ceiling to bottom of the range hood filter surface: D-A-C=B C. 29” (73.66 cm

6 VENTILATION REQUIREMENTS Range hoods must be ventilated to the outdoors Do not ventilate the range hood into an attic or other enclosed areas.

7 Calculating Vent System Length To calculate the length of the system you need, add the equivalent feet (meters) for all vent pieces used in the sy

8 INSTALLATION INSTRUCTIONS PREPARING THE LOCATION It is recommended for the vent system to be installed before hood is installed. Before makin

9 Air Flow Flapper Preparation 5. Mark the flappers location under the cabinet. 6. Cut out a rectangle a little bit larger than the air flow flappe